Home› Learning Centre› Burning Smell From a Plug Socket or Fuse Box? What To Do Right Now
Electrical Safety

Burning Smell From a Plug Socket or Fuse Box? What To Do Right Now

A burning smell from a plug socket, light switch or fuse box is one of the few electrical problems you should never wait on. It almost always means something is overheating, and overheating connections are a leading cause of electrical fires in UK homes. Here is exactly what to do, in order, and what is most likely behind it.

If you can see smoke, flames or sparks, call 999 first

Get everyone out of the property and call the fire service. Do not try to put out an electrical fire with water. Everything below is for a smell with no visible fire.

What To Do in the Next Five Minutes

1. Do not touch the socket, switch or plug if it is hot, discoloured or melted. A scorched faceplate can have live parts exposed behind it.

2. Switch off at the fuse box. If the smell is coming from a socket or switch, turn off the main switch on your consumer unit. If the smell is coming from the fuse box itself, only touch the main switch if the unit is not hot, crackling or visibly scorched. If it is, leave it, keep away and call us.

3. Do not reset anything that has tripped. A breaker or RCD that tripped at the same time as the smell has done its job. Switching it back on puts power straight back into the fault.

4. Open a window and note what you noticed. Where the smell was strongest, whether anything was plugged in, and whether you heard buzzing or crackling. This helps the electrician find the fault faster, and faster means cheaper.

5. Call an electrician. Our emergency electrician service in Liverpool runs 24/7 and a real person answers the phone.

Why Does It Smell Like Fish?

A lot of people describe the smell as fishy rather than burning, and it confuses them. Many sockets, switches and older fuse boxes are made from plastics that give off a fishy smell as they overheat. If you smell fish and there is no fish in the house, treat it exactly the same as a burning smell. It is often the earliest warning you will get, before any scorching is visible.

The Most Common Causes

Where the smell isMost likely cause
One socket, with a heater, tumble dryer or kettle plugged inHigh load through a worn socket or loose terminal
A socket with an extension lead or adaptorOverloaded lead or adaptor overheating
A light switch or ceiling roseLoose connection, or a bulb too powerful for the fitting
The fuse box or consumer unitLoose connection at a breaker or main switch, or a failing component
Near the electricity meterLoose meter tails or a fault in the supplier's cut-out
An appliance, not the wallA fault inside the appliance itself

The common thread is a loose or high-resistance connection. A terminal that has worked loose over years of heating and cooling stops making full contact. Current still flows, but through a smaller area, and that point gets hot. It can carry on quietly for months before you ever smell it, which is why the smell should be taken seriously the first time.

Is It Safe to Wait Until Tomorrow?

Not with the power on. If you have switched off the affected circuit and the smell has gone, the immediate danger has passed, and you can decide whether to book the next weekday slot or call us out of hours. If you cannot isolate just that circuit, or the smell came from the fuse box, call straight away.

Do not plug the appliance into another socket to see if it still smells. If the appliance is the cause, you move the fault. If the socket is the cause, you load a different circuit while the faulty one is still unchecked.

Older Liverpool homes are more at risk

Many Victorian and inter-war terraces across Liverpool still have older wiring, rewirable fuses or consumer units with no RCD protection. In these properties a loose connection is more likely, and there is less protection when one fails. If your board still has fuses rather than switches, read 7 signs your fuse box needs upgrading.

What the Electrician Will Do

We find the source first: the socket, switch, fitting or board connection that has been overheating. We check the circuit for damage either side of it, because heat travels along the cable. Then we replace the damaged accessory, remake the connections properly, test the circuit and switch you back on. If the fault is in the supplier's equipment at the meter, we will tell you and you will need to call 105, the free power cut line, as only the network operator can work on it.

What It Costs

We charge by the hour, with the same rate for finding the fault as fixing it. It is £120 an hour Monday to Friday, 9am to 5pm, and £150 an hour evenings, nights and weekends. There is a one hour minimum, then 30 minute increments, parts at cost, and no callout fee on top. A burnt socket or switch is usually a straightforward replacement once it is found. A fault inside the consumer unit can take longer, and if the board is old we will tell you honestly whether repair or replacement makes more sense.

Burning Smell? Call Now

24/7 emergency electrician across Liverpool. A real person answers. No callout fee.

Related Guides